MicroView: the bad, the good, and the awesome

[terriko]

This is crossposted from Curiousity.ca, my personal maker blog. If you want to link to this post, please use the original link since the formatting there is usually better.

I backed this cute little thing on kickstarter called the Microview, which is basically a teensy arduino with an oled display attached. It was too adorable to pass up: I’ve wanted a little programmable necklace for a while, and this meant that project would be really easy to build.

My MicroView (Adorable Arduino with OLED display)

I’ve been anxiously awaiting the arrival of the MicroView and it finally came today. So I popped open the instructions page and the first thing I see is a big apology. Uh oh…

So I check my email and sure enough, there’s an email about a big problem. Short version: they sent out a whole pile of units without bootloaders, so it runs the demo but won’t run any new code. Both of my MicroViews, it seems, are in the affected batches. More details here:

https://www.sparkfun.com/news/1575

https://www.kickstarter.com/projects/1516846343/microview-chip-sized-arduino-with-built-in-oled-di/posts/959475

So that’s disappointing, but they’re shipping out replacement units, and I suppose I can wait a bit longer to play. It’s not like I don’t have other toys to play with.

But here’s the super awesome news: it’s possible to dissect the unit and fix it!

So… with a bit of hacking, and assuming I don’t break anything, I may have double the number of MicroViews by the time this is done, and I’ll have had an excuse to dissect my new toys.

I’ve never been so pleased about receiving a defective product.

In the meantime, I guess I can play the tutorial game:

MicroView running the tutorial “game”: Connect a jumper between pins 5 and 8